Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| wsrtinfo:sensoralarmdescription [2009/08/24 07:11] – arnoschoenmakers | wsrtinfo:sensoralarmdescription [2009/08/24 07:11] (current) – arnoschoenmakers | ||
|---|---|---|---|
| Line 32: | Line 32: | ||
| * Setting the alarmstatus of all the associated sensors to '' | * Setting the alarmstatus of all the associated sensors to '' | ||
| - | Before obtaining the values, we first check if the sensor database values are recent enough to trust. This limit is set at 10 minutes, i.e., only if the database contains values less than 10 minutes old, the alarmconditions will be evaluated. All values are taken from the local MySQL database (the one running on wop33, that is). | + | Before obtaining the values, we first check if the sensor database values are recent enough to trust. This limit is set at 10 minutes, i.e., only if the database contains values less than 10 minutes old, the alarmconditions will be evaluated. All values are taken from the local MySQL database (the one running on wop10, that is). |
| In the '' | In the '' | ||
| Line 127: | Line 127: | ||
| ===== Alarmconditions ===== | ===== Alarmconditions ===== | ||
| - | This is the Alarm conditions table that is used in the software. It originates from the file ''/ | + | This is the Alarm conditions table that is used in the software. It originates from the file ''/ |
| ^ Sensor ^ Type/Unit^ Alarm Condition(s) ^ Nr. of samples ^ Mail/SMS who ^ (Software) Action ^ | ^ Sensor ^ Type/Unit^ Alarm Condition(s) ^ Nr. of samples ^ Mail/SMS who ^ (Software) Action ^ | ||
