Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| public:stopdayactivities_170818 [2018/08/14 12:53] – [WSRT stop-day activities August 15, 2018] teungrit | public:stopdayactivities_170818 [2018/08/15 14:25] (current) – [Results] teungrit | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| * Enable write cache of the RAID controller of wop85 | * Enable write cache of the RAID controller of wop85 | ||
| * Try to isolate the memory errors on wop61 (switch off ECC in BIOS and run mem test) (There is a spare system, where you can take the memory from) | * Try to isolate the memory errors on wop61 (switch off ECC in BIOS and run mem test) (There is a spare system, where you can take the memory from) | ||
| + | * Connect lcu-rt0 (both IPMI and eth0), Install Ubuntu 14.04 latest, run Ansible playbook | ||
| + | ==== Results ==== | ||
| | | ||
| + | All the systems above were updated and rebooted. | ||
| + | We ran into several issues: | ||
| + | * wop59 Supervisor did not start. Reinstall did work. Started by hand (all systems), although it was " | ||
| + | * Hypervisors: | ||
| + | * wop63, wop75: Network config needed to be changed. It was starting bridge one first (" | ||
| + | * wop54: The disk check to quite some time | ||
| + | * wop61: We tested the memory with "ecc off". A number of errors appeared. (We have spare memory for this one) | ||
| + | * wop61: Added Zabbix check on memory errors | ||
| + | * lcu-rt2..lcu-rtd: | ||
| + | * lcu-rt2..lcu-rtd: | ||
| + | * jip updated and rebooted after 489 days | ||
| + | * After LCU update one needs to start the qpidd federation on ccu-corr | ||
| + | |||
| + | For a complete overview, see https:// | ||
| + | |||
