This is an old revision of the document!
Release notes LOFAR Offline release 2.15.0
Administration
Release Date: Jan 25th 2016
SVN tags:
Instructions
In order to build the LOFAR tree for reelase 2.15 you will need to first install the AOFlagger. Installation instructions for the AOFlagger can be found here: http://sourceforge.net/p/aoflagger/wiki/installation_instructions/ Please note the following:
- To be able to use AOFlagger with LOFAR build, set the AOFlagger build flag: “-DBUILD_SHARED_LIBS=ON”
- In LOFAR build, use the Cmake flag “-DAOFLAGGER_ROOT_DIR=<your aoflagger install dir>” to link to the local AOFlagger.
- If you have an older system (like our CEP2), you may not be able to build the graphical tools with AOFlagger. The LOFAR build will by default build them for you. If you want to make use of the tools provided by AOFlagger build, you will need to explicitly tell to not build these in the LOFAR build using the Cmake flag “-DBUILD_AOFlagger=OFF”
Further build instruction for building the LOFAR release can be found here:http://www.lofar.org/operations/doku.php?id=public:user_software:lofar
Release notes/changelogs
PyBDSM
- #9020 - PyBDSM island masks are incorrect when two islands are very close together
AWImager
- #8859 - Add option to pyparameterset to remove quotes
BBS
DPPP
- #8912 - Show IO statistics in DPPP
- #8820 - Initialize DPPP logger properly
- #8967 - Segfault in GainCal
- #8989 - GainCal leaves some data uncalibrated dependent on minblperant. WARNING: Calibrating flagged data will now mark a solution as 'Flagged', where previously it would write a solution with value 1.0. If you apply the flagged solution (with DPPP gaincal or BBS), your data will now be replaced with NaN and flagged. Please do not flag stations if you want to leave them out in a calibration run. Instead, filter them out using
msin.baseline
or a DPPPfilter
step.